VR Expansion Plugin

[dcaspi]

@;723282

Climbing is a directed movement mode, it doesn’t obey gravity or have any default movement logic, you directly control the movement. If you want to do zero G you should be turning off the auto step up for climbing (boolean in the movement component).

Then you should set these:
DefaultLandMovementMode = Flying
GravityScale = 0.0
Modify friction settings to your liking

For pushing off of things without directly climbing on them, just AddImpulse to the character off of the penetration depth, the rest of it should just “work” with those settings, as when you stop climbing it will enter Falling mode until it touches a floor where it will enter flying mode.

will get it working without heavy modifications, if you want a REALLY GOOD low G movement setup there would likely be custom logic you would have to handle to force things like falling all of the time instead of flying after landing on the ground.

2. is a VERY BAD idea, it basically creates the running into the wall effect with ANY positional real world movement, I don’t directly have support for turning off or range limiting the HMD tracking (at least yet, doing vehicles correctly may require range limiting), with normal characters you would set bLockToHMD to false on the camera, and you could do that with the plugin as well but the capsule will still follow the HMD due to default behavior. You can force it by moving the actor to offset for the HMD movement difference if you really want to test it…if you don’t offset the actor then the hands will be in the wrong location as they are not relative to the HMD but rather relative to the actor root.

Thanks a lot for you replay!
I still experience the same problem, basically now that I climb I can “push” myself up I go up infinity unless I grab the box.
In my test I grab the top box on the right and tried to “push” myself to the left to be “floating” to the left side until I grab a different box or reach a wall.
But when I try to push myself to the sides (working good with up and down) it seems like there is no force.
I tried to check what cause force to be applied when going up and down but I got a bit lost in the blueprints :
Hope if you can help or point me in the right direction.
I hope its clear enough…

Thanks,
Doron