Does anyone know who created the Tropical Ocean Tool? (found on the Marketplace) I have finally got it to scale to my environment, and it has taken hours to figure that out. Now I need some help getting the waves to travel towards the beach. I have followed the technical video but it only skims the surface and I need more guidance.
Is the creator of this shader available for me to ask questions any one know who he is?
Go to the marketplace page for the product. Select the the creators name which will bring you to there page where you can find the contact info.
@ I’ve used this tool. For each island you want waves around, you have to increase the island counter in the parameters ( accessible in editor ). I’d start with ‘1’ and work from there.
When you’ve set the number of islands to ‘1’, you’ll see a little square on one corner of the water mesh. This is the end node of a spline. Drag this node so it sits next to the coast of one of your islands.
Then treat it as you normally would a spline, ( I can’t recall right now, CTRL-click or ALT drag ), and you can add spline points and make a loop ( you only need 3 points to start with ).
The moment you do this, waves will start appearing at the points. If the waves are going away from the island, it just means your spline is ‘inside out’. You can fix this by dragging one of the points ‘over the opposite side’ ( just drag the point so that the loop becomes a line and then go further until it’s a loop again ).
That should get you started 