[SUPPORT]CAMERA 360 v2. System

[Ivan_Elizarov]

Hi!
Sure, no rpoblem, you need changes in PostProcess.
Vignette = 0.
Bloom =0.

[SUPPORT] CAMERA 360 System

Thank you very much Suk Young Choi, helped to find another post processing, from which appeared seam. The seam is difficult to see, but when you turn on bloom, it may appear from behind. This does not interfere, but if You need to remove it, just change the value of bloom. Decision. To put the postprocess bloom=0. [Seem1.jpg]

This fix works for all versions of the 360 camera.