Light target on Torch?

[kongkim]

@P0k3r;479743

This how I have the particles setup for the lightsabers -

Setting the outputs to anything but 1 makes the emmissive glow around them way to much so they are all set to 1. Also, on the sword I found that if you set the values higher in the “Initial color”, it seems to carry over to your changed settings. IE: Turning the initial color values up will make it a little brighter when colored

The easiest way I have found to find what each setting does is to check the red x next to it to turn in off

Thx P0k3r
Im trying to get it right and i got it to change range and color on the light and brightness. It seems that when i change values/color with parameter it always change the Constant field?
So need to set alle parameters first and then change that with actions.

But with now i have two problems that annoy me. I can change color on the flames. in the partical system. But it do not change when i run it by a script… But the same script works on the light color… I tried with having the same parameter names and also give them their own.

And problem 2. If i boost the light range to double the range. and have the back to the torch the light turns off at normal range and the light turns off?? Where do i set that out of range not looking at the torch thing :D?