cant get swarm agents to render

[werx60]

Hi all,
I have some weirdness going on with swarm. I believe its setup properly but its not working. I have 2 render boxes that I want to us but its not happening. When I ping them I get no error messages, they are excluded from the firewall. When I open up the coordinator they are listed and available.

When I build I get the following error in the log.

Anyone have anything that I can try. I am about done for today trying stuff but if someone has run into this I will try.
Thanks
Alex

[Metathesus]

Do you use the Luoshuang GPU Lightmass?

[werx60]

I have no idea what that is so I would say no I do not.

[NasteX]

I get those errors too (if you are talking about the Failed to load ones) but swarm agent is working with no problems at all. The first thing I notice is that you have made a different agent group names, why? I have always used the Default names for the last 3 years.

How did you exclude the swarm agent in firewall? By using the advanced firewall settings or by using the command prompt?

[werx60]

I will tried both ways with the naming. I will double check and make sure its the default. I did it by advanced firewall settings.

[NasteX]

Try to exclude the swarm agent like this.

"Programmatically, the Windows Firewall can be configured to permit Swarm usage with the following commands. We also do IP filtering to make sure these firewall exceptions only happen on our local network — replace x.y with your actual leading IP octets.

• Allow Swarm ICMP pings: netsh advfirewall firewall add rule name=”Unreal Swarm” dir=in action=allow enable=yes remoteip=x.y.0.0-x.y.255.255 protocol=icmpv4 interfacetype=lan
• Allow Swarm TCP commands: netsh advfirewall firewall add rule name=”Unreal Swarm” dir=in action=allow enable=yes remoteip=x.y.0.0-x.y.255.255 protocol=tcp interfacetype=lan localport=8008,8009,54430,56574,56587 remoteport=8008,8009,54430,56574,56587"