I used the vehicle tutorial videos to create a video. Everything works. It drives fine. But the mesh is somehow vertically offset. It all lines up in the physics asset editor, the mesh and the bones. No obvious problems. I used 3ds to make a quick mes its very rudimentary as you can see. I have messed around for about 2 hours trying to sort this out. Any ideas?
Hi there,
Check your Wheel Blueprints (both front and rear) and try adjusting the wheel size down, it needs to be set to the actual width of the wheel itself, it defaults to 30 but that may be too large in this case.
If you are able to drive it around, that should be the reason, but let me know if that doesn’t work. Thanks!
That was it. Once I made a new blueprint and adjusted it, that fixed it. Thanks alot!!!