Updated UI Designer Quickstart Guide?

[UIPerm]

I have been going through the UI Designer Quickstart Guide and seemed to have run into a snag. In step 14, the Add to Viewport Node does not specify a Target.

However, when I try to complete Step 7 in Adjusting Character Variables I cannot compile as I get the following error:

This is how my flow is set up, based on the instructions:

Note that the Add to Viewport node has Target set to self. What should it be set to?

[DocMont]

@UIPerm

I have been going through the UI Designer Quickstart Guide and seemed to have run into a snag. In step 14, the Add to Viewport Node does not specify a Target.

Note that the Add to Viewport node has Target set to self. What should it be set to?

Hello UIPerm,

This forum is meant for documentation feedback, for specific project troubleshooting please post your future questions on our Answerhub.

As the compiler warning states “Target” must have a connection, you will need to connect your HUD Reference output variable into the Target node as shown in the image below.