Another thing that might not work properly is Gear Setup > Up Ratio.
The following image No.1 shows the Up Ratio at the first 3 gears set to 1.0. Meaning, the gears will change to the next higher one only when maxRPM is reached (currentRPM/maxRPM = 1).
Well, the buggy is stuck in first gear. That’s not to bad, since 1.0 is an extreme figure, 0.95 works also. But still, maxRPM is reached, so it should work, but that’s ok.
This image No. 2 shows only the first 2 gears set to 1.0. One would imagine, the buggy would also be stuck in the first gear. HOWEVER, the buggy drives fine and reaches all gears from 1-5.
Again, this is a completely fresh project. And again, I might miss something.
What I am trying to achieve, is a car that has a very senstive first gear. Where too much throttle means too much torque and therefor wheelspin.