Hey man, nice to hear from you again, my guardian angel hahaha
Here are both the initial file and the exported file.
I believe it was based on OSGB.
I am just trying to test the quality of mesh model production, the previous project was way too big to view and even export/load into other softwares so I am trying a smaller project which, being totally honest, isn’t near as organised as the previous one.
Your advice helped a lot on the previous project and I compared my cloud and ortho results to DJI Terra. I found the ortho wasn’t as clear as Terra when zooming in and point clouds were roughly the same.
I was advised on a post-processing clean-up software which I can’t seem to figure out quite just yet and I was also advised on a software to check pointcloud accuracy too.