I been having trouble with this for a while now. And couldn’t find a work around. Everytime I switch camera with blend set to 0 and everything set to 0. There is a lag of some sort where I well see a white flash for 1 frame(which is the skysphere) in between the switches.The camera it is switching to is inside a box under the level. What method do I use so you can’t see the “white flash”.
If you aren’t actually blending the camera movement then remove the blend and simply activate/deactivate the cameras as needed and appropriate.
Hope this helps
As said in the original post I have everything set to zero.
Yes, I saw that but you are still trying to blend. You said:
I well see a white flash for 1 frame
The blend node, while set to 0 is still a blend node. You see a white flash that lasts for approximately 1 frame. This leads me to believe that it’s because of the blend that you are seeing this, even though it’s all set to 0. Remove the blending and simply activate/deactivate the cameras accordingly. If this doesn’t help, we can move on with a possible other test and/or solution.
Just because you have gas in your car doesn’t mean that it should start. You need to eliminate all possible causes and diagnose from there.
Hi,
This answer is probably about three years too late for the OP, but…
…this flash (for me, at least) is actually caused by the occlusion culling.
You can prove this by disabling it temporarily (Project Settings->Rendering->Culling) and voila!
I hope this helps someone!
@mikeyj21 this answer is also years later but I wanted to say… thanks!
BTW, I wonder how much disabling the culling will impact the performance…