[SUPPORT] Advanced Turn Based Tile Toolkit

[xiuxiu]

@;326229

@xiuxiu: Thanks, glad you like it I assume you’re using your own custom static meshes for tiles? The easiest way to fix your problem is to make sure the pivot point of your static mesh (set up in whatever modeling sotware you are using) is at the top and center of your mesh. I did this with my own meshes as I thought it made sense that the “floor” of the grid was at the same Z location as the Z location of the grid, and so I would not have to correct for the height of the meshes in blueprint. I assume the pivot points of your meshes are in the center of your tiles, since you have to add half their tile bounds.

Thanks for reply so fast.
I agree that the pivot should be at top as floor. Please ignore my request, I’ve just found it’s hard to use it in my own project without any modification.

Any idea about fog of war? I can only show/hide them, it’s sad:(. Ok, it’s a little far from this post, don’t mind.
I am strongly looking forward to this toolkit’s new version.

Good job!