I process approx.1500 pictures taken from copter (almost vertical) and taken by hand. Both sets were captured with different cameras but each picture has its own calibration group (close range photogrammetry with autofocus). It was possible to connect all pictures in to one component but resulting mesh has strange spots. It looks like combination of two groups of pictures with different hight. Height difference is only one cm but it is quite significant because it corrupts whole mesh.
I would like to ask what could I try to get rid of these artefacts?
Hi Grundmann
It’s a result of misalignment… You mentioned calibration groups, have you created them ?
Try to ALIGN and then export reconstructions as COMPONENTS and then align them in one complete set. The misalignment can be caused by a few PANORAMIC camera pictures…