Spread main connection into two nodes?

[Dimshvaebene]

@DImshvaebe

does sequence requires 1 to completely be done and then proceed to 2 ?

my method is good but I reach a problem where I need a big gap between delay timers. On the picture you see Reset boolean node will be set to 0 after 0.5 seconds and on the other node request delay is 0.500001 seconds which should pass without problem however it does not.

The gap i need to set is larger than 0.02 seconds and this is a lot, for example if I set left delay to 0.4799 and right to 0.5 everything will work fine and signal will be passed to False from the branch (the way I want to be)

if by any chance I reset the whole process at this exact 0.02 seconds I will have bad result

actually it fails, it kinda works like sequence, I still need to fire from pin and just at the same time to start a delay for another place