Hi all.
Not sure when this happened ore of this has been an ongoing issue but the Z for the sockets on my gun’s skeleton seem to be locked:
(Firing left to right)
The system uses actual projectiles and those fire out correctly regardless of where I am aiming. However, when I went to implement line tracing to configure recoil, the trace shoots out at two angles, hard left and hard right. It seems to be choosing either -180 or 180 based on a relative world rotation.
The thing is I havent set anything like this and it is happening for multiple sockets. When the line trace is attached to say my ADS camera socket, it persists. Again bullet projectile no problem. I have reset the socket rotation in the skeleton to no avail.
To troubleshoot I spanwed a Niagara System to mimic a muzzle flash and the flash rotates the opposite way of the muzzle but only when there is a change on the Y axis?..
Any suggestions on how I should go about further troubleshooting this?
Has anybody come across this before?
I will create a video to show if it helps.
Thanks!