ok, I had the same issue and had to take the long way around to get the needed answer.
So here we go…
-
Make sure all of the material that you want to blend are downloaded…
-
In your content browser create a new folder name is blend material.
-
Go into Quixe bridge, pick your base material that you were going to use in your blend.
-
Go to the filter section give it a new name, go down to the path and make sure it goes to the new blend material folder that you made( that is important!) click create material and go back to UE.
-
look in your new folder you will see your base material
-
double click on the material
-
once the material window pop open, please to the following:
- Click the box for puddle layer
- go down to the base layer, middle layer and top layer change only the what is needed for each those areas ( if the base layer is correct leave it alone and go to mid / top layers and change the needed area with what material you need to have in this blend)
- check over everything!!!SAVE and test it out!!!
I hope this helps. 