For some reason the masks i’m generating are slightly offset from the original image. The image attached is what it’s showing me in RC but i’ve also compared masks against the original in photoshop to confirm it’s not a display issue. My original images recognize the mask in the mask layer metadata and it appears to be the correct masks despite it being misaligned so it’s not a naming thing. I’ve generated masks for two different sets of image multiple times with the same offset issue. Any thoughts?
Hi drossxyu,
this is very strange. What are your mask export settings?
Are you exporting masks from Preview or Normal detail model?
Is this also happening after application reset (open RC with pushed SHIFT and choose the option Make it like a clean install)?
Export settings are default except that I disabled export camera depths. Exporting to same location as my original images. Exporting from preview. I did an application reset w\ clean install option before hand when troubleshooting.
So the application reset didn’t help…
Is this also happening for some other project? The size of the images and masks is the same? Would it be possible to share this project with us?
Yes, I can share it. What’s the best way to package it up for you?
I sent you the invitation for upload.
Uploaded. Cheers.
Thank you, I will check the data and let you know about my findings.
Hi drossxyu,
is it possible that you had set Undistort images to Yes during export masks?
If so, it should be set to No to get the same masks as images.
When I had it to set to No, the masks were the same as images, when it was set to No there was the same error as you had.
Very possible! Is that a default value? If so, I probably left it on. I will try it on my end shortly. Much appreciated.
No, it is not default value, I suppose it should be set to No as default.
If you want to use undistorted images. But then also those images should be exported.