Procedural Nature Pack - Vol.1

[Jacob-3D]

@somawheels;422915

Hi, my water refelctions are on their side! I half found the source of the problem; the overall surface normal - therefore reflections - are tilted by a few degrees each time you plug a “BlendAngleCorrectedNormals” into another “BlendAngleCorrectedNormals”.
I know this because if i replace that material function with a “Blend_overlay” function, or just get rid of the “blendAngleCorrected normals” nodes, my reflections are orientated as they should be.
Any ideas why the “BlendAngleCorrectedNormals” is tilting/offsetting the overall normal/reflection?

Hi somawheels,
I never noticed this problem before, but I will definitely check it out in the engine. Have you found any “fix” for it or only so far the source of the problem being the BlendAngleCorrectedNormals? I might be able to get a chance in the next weekend or two to find a fix for it if you don’t have any luck. Thanks for the feedback!