Physics

[Wranglerltg]

@ConnorTheScot;520460

Hi Wrangler,
Not a problem.

I suspect that all you have to do is tick the ‘Simulate Physics’ box on the static mesh component of the blueprint actor.

If you open the relevant blueprint, then navigate to your Static Mesh Component, i.e your glass, and then tick the ‘Simulate Physics’ checkbox, this should [all going well] now allow the glass to be affected by collisions.

Hope the above helps,
Connor.

Thanks! I’ll give this a shot after 4-5 hours of sleep. I’ve been searching on and off for a few days and it was beginning to annoy me. This seems pretty straight forward. Would you mind if I contact you if I need a little clarification.