Mesh question

Hello i,m new to CR, but i have knowledge with other similar programs,
i just discovered the demo a few days ago, and i m very impresed with the speed and results with CR! :shock:
The Free Demo is over now, i could not test much the last 2 days doing Mesh from the Cloudpoints, and with the free Trial
there is aboslutely no option to see Mesh? even without saving, or am i wrong here?
Can CR close holes in the Mesh? Is there an option in the full version? My Other question is there a smoothing the Mesh option.
I hope you understand my questions.

greets
Nedo

Hi Nedo

i just discovered the demo a few days ago, and i m very impresed with the speed and results with CR!
thanx

The Free Demo is over now, i could not test much the last 2 days doing Mesh from the Cloudpoints, and with the free Trial
there is aboslutely no option to see Mesh? even without saving, or am i wrong here?
no the demo not offer any mesh export. From November up to 31.1 it was a trial version with exports

Can CR close holes in the Mesh? Is there an option in the full version? My Other question is there a smoothing the Mesh option.
I hope you understand my questions.
not now supported, but close hole can be done in many post work sw like Zbrush or Meshmixer and etc…

Checking up on this. Is CR able to fill holes yet??.. It’s been a couple of years.