MESH processing stuck half way

Development Asset Creation
, ,
1

Hello, I’m trying to create a high definition MESH from more than 2000 photos.
Alignement is ok, model is made of more than 5 different components.
I tried to do the high detailed MESH, but it’s stuck halfway through process (blue bar is half way and it’s not moving) even after a whole night of processing.
When I openned RC console, I saw that RC estimateed I needed 50Go of RAM to process it, but I only have 32. Can it be the cause of it ?
RAM was used to it’s maximum.
I tried to pause it with checkpoint, but it always get stuck at the same moment.

Any tips on what can I do to avoid getting stuck ?
Cheers,

Components hardware :
32Go RAM
i7 12700KF
RTX 4070 SUPER
SSD with free space (260Go)

2

Hey,

In that case, I recommend you manually set your swap file (page file) in Windows to 150% of your current RAM, so you would have 32GB+ 150%. In short, the swap file allows your computer to pretend it has more RAM than it actually has. It’s best to use an SSD for this and make sure you have enough space on the SSD.

Here is a link to how you can do It:
How To Manage Virtual Memory (Pagefile) In Windows 10 | Tom’s Hardware

Best regards,
Jakub