We recently captured images from a small square building, where the ‘loop’ was closed. However, the software is failing to recognise that there are four sides to the building. I have followed the online ‘help’, but the system is failing to recognise the ‘loop’.
If I register all images together in one go, I get the same output.
Any ideas or suggestions will be gratefully received!
The ‘wrong’ alignment can be seen in the attached:
If registered separately, the four walls look fine:
Hi there,
you have too little images, especially when you go around the corners you need to take a lot of images and make only small changes to the angle. Do you have the chance to go there again? Also consider to make a close-loop and a second far-loop in around double distance to your object.
All the Best
Max
Just as maxion correctly mentioned. you should be adding another elevation above this line and shoot a bit more, one line of images meter by meter will mostly not make it.
If you can’t go back on site to take more pictures, you should consider adding control points to join the components together.
Thank you so much for this advice. The reasons for taking a relatively small number of pictures were down to some site conditions on the day - both space and ‘social’ (I’ll not bore you with the detail!).
I will try to add control points, and failing this, I’ll take a drive back to site.
Thank you once again.