Hello. Here is some general feedback I have with regards to RC and point editing in particular.
-
Polygonal selection and lasso tools are badly needed (similar to CloudCompare or Agisoft PS). The volume cube approach is too blunt for cases with highly concave surfaces(such as rocks) where I need to trim off all excess ground around the base. Cleaning up one rock via rotating the volume around took 20 minutes whereas with lasso it would only have taken about 1 minute. Additionally, it would be best to trim areas in the point cloud phase rather than afterwards since I would have texture space wasted on portions of the model I don’t want.
-
Rather than just filter/remove a section of points it would be beneficial to have the ability to duplicate the selection off into a new model similar to how CloudCompare handles it. This would be useful, for example, in cases where I capture a large area of ground but want to pick and choose areas of it to keep and make meshes out of.
-
Current filtering tool bounding box is too transparent and makes it hard to tell while positioning if it is intersecting a point or not.
Thanks
