I hate when that happens. Fingers crossed you notice this message.
This is a fantastic tool siebencorgie! I’ve run into a few problems with the initial setup. I noticed that you have set it up to automatically detect the bounds of the mesh and then set that as the spacing amount which is awesome, however, based on stretching (squishing really) happening on the texture and the wireframe view, it looks like it’s compressing the mesh in the middle an at the ends. Notice how the spacing of the subdivisions is smaller in these places but in the mesh they’re evenly spaced.
http://torquemod.com/RoadToolSpacing.jpg
Also, I’m curious why there are 3 array elements for the SplineMeshComponent? Couldn’t you just use one? I added the same mesh there 3 times but I’m not sure if that was your intention.
Thanks for the help!