Flipping object for reconstruction of base.

Development Asset Creation
,
1

Hi

Just after some clarification about how I can reconstruct a full object including areas occluded by the ‘stand’.

I elevated my object to capture as much as possible, but to reconstruct the total base I was forced to flip and shoot again the underside. The two components aligned well after locking the first photoset.

I think that I have to externally mask out the stand and turntable (as in the attached picture) but I wanted to ask if that is the only current way.

A great solution would be to allow mask generation from a cleaned up mesh, as per Agisoft.

Thanks!! :smiley:

2

Easiest solution: Make sure the stand has the same colour as the background. black in your case.

Also, I recommend doing another set of pictures with the object 90° rotated (sideways). That helps RC not only with aligning the two “sides” but also with telling the stand apart from the object.