Hello there,
I often have to render Non-Sequential Frame Ranges or a selection of certain frames I want to render. So far I haven’t found an obvious way to do that, except filling up the queue with different frame ranges in the render settings.
Example:
I have Sequence XYZ that goes from Frame 0-200. I only want to render frames 5, 34, 105-110, 66.
In this case i would have to make 4 render settings each differing in the frame range.
Would be nice to have a textfield in the render settings where you just type in what frames you want to render. Hopefully I did not miss it in the new render graph but from what i recall its the same as the MRQ setting.