I was trying to figure out how to export only the part of my point cloud that is within the reconstruction region. Sadly every time I export I go to reconstruction–> export–> model I get the whole cloud. I also tried to have a clipping box and have it match the reconstruction region but I get the same results.
Any help would be very appreciated
Hi,
The clipping box is just to view a certain part of the model and does not effect the export. If you need to export a point cloud smaller than the one you reconstructed, you will need to set a new reconstruction region for the bit you want and reconstruct again just that part (a new model will be made) and just export that model. Or you could filter out the triangles you don’t need, and export that model, but this will give rougher edges. Export will always export the entire model so if you want to export a smaller model you will need to use one of these techniques to make a smaller model.