Export Mesh/Ortho to J-TSK

Development Asset Creation
,
1

Hello,

I am having hard times exporting my model in J-TSK coord. system. My GCPs are in J-TSK and the model has been calculated. When I click on a ground control point, the coordinates are in the form is X=-74…, Y=-104…, Z=180m. This is okay!
When I export the model to xyz file, the coordinates I get look like this: X=-25.734…, Y=8.044…, Z=0.399.

Could you please give us some info regarding exporting in J-TSK? The previous version had an option ‘preserve coordinates’ regarding the reduction. Now the current versio doesn’t have it and it is a bit complecated to reduce any coordinates.

Thank you in advance for your information!

Best Regards,

Paulina Raeva

2

Dear Paulina,
you need to select “Project output” coordinate system instead of the “Grid Plane” from the “Coordinate System” during export of the model.

But before you will export your model, you need to setup your “Project Output” coordinate system in “WORKFLOW -> Settings -> Coordinate Systems -> Project Output System” to the J-TSK coordinate system.

3

Hello Michal,

I took your advice.
I processed the whole project with GCPs in J-TSK and the project itself was in local system. When I changed it to J-TSK, which I don’t think is proper, and exporeted the model according to what you’ve written, I received an error.[/img]

Could you please explain the meaning of Converted position, Actual position and Alignment report?
If I work in a loca system, can I export the model in the same system?

Thank you!

Ragards,
Paulina

4

Hi Paulina

Do you get the invalid function call issue just at the beginning of the export or anywhere later ?

5

Hello,

I start the export and after some time I get the error. So it is not in the beginning of the export.

Wishgranter wrote:

Hi Paulina

Do you get the invalid function call issue just at the beginning of the export or anywhere later ?