Cycle through images that share a control point

Development Asset Creation
,
1

Hi All,

Apologies if this has been asked already, but haven’t found an easy way of doing this. Is there are way to cycle through just those images that share a control point? If I use the arrow keys in the 2D view it cycles through all images. I want to confirm that I haven’t mistakenly added a point through a mis-click, but I don’t seem to be able to drag-and-view images from the control points groups, or limit a view to showing only those.

Thanks!

2

Hi Philip Boltt

Look at the 1Ds view on the left side, there are control points (CPs)

  1. set the 2D window to have a BLUE color ( click in the 2D view and in the contextual window you can set 4 colors, set BLUE )
  2. click on any of the images under Control points and it will be shown in the 2D view, then just click on the images (under CPs) with the same CP.

or workflow 2:
use ALIGNMENT -> POINT LASSO -> select a small area of points around a particular CP and use FIND IMAGES – this way you will get a selection of cameras seeing the selected points. then in 2D you can use the arrow keys to switch between images of that selection…

3

Hi Wishgranter,

Apologies for the late reply. This is perfect. Thank-you!