Hello Jeremie,
at 3:12 in the video you use a parameter at length percentage node to evenly distribute the bones on the spline.
I don’t understand why this works !
The output from the previous for-each node ( ratio ) is a parametrized 0 - 1 value.
The node Parameter-at-length gives 0 - 100%. So why does a ratio going from 0-1 work on a node where the input requires 0 -100% ?
Unless its just incorrect wording. i.e the Parameter-at-length actually takes in values between 0-1 (and not 0 -100% ).
Thanks for clarifying this.
Cheers for the awesome series.
b