I tried, but I failed yet again lol. I changed the rotation in small doses but once the Z rotaion hits -180 it goes back down through 0 to get to + 170 which is only like a 10 degree difference. However at the end of the vid I see that if I adjust the Z rotation in the details panel it changes from “-180 - +180” to "0 - 360 degrees. When I test it out by always adjusting the rotation in the details panel the problem doesn’t occur but it just seems like one extra step. Is it because I’m piloting it or something. It’s wierd to me but I am an eternal noob who does this for fun lol. I appreciate the assist. 