It stalled again during texturing and I did not save the last step before starting this process.
Since I worked quite a bit with CPs before, I just minimized and exported them.
It let me do all this without complaint, so I aborted after.
Again, the process could not be terminated and I had to reboot, but this bug is already reported.
Contrary to all indications, the CP-file was NOT CREATED.
So I lost quite a bit of work here.
If the file creation cannot be accomplished, there should be an error message…
Götz Echtenacher wrote:
It stalled again during texturing and I did not save the last step before starting this process.
Since I worked quite a bit with CPs before, I just minimized and exported them.
It let me do all this without complaint, so I aborted after.
Again, the process could not be terminated and I had to reboot, but this bug is already reported.
Contrary to all indications, the CP-file was NOT CREATED.
So I lost quite a bit of work here.
If the file creation cannot be accomplished, there should be an error message…
Hello again,
what export settings (which format) did you use?
Well, there is also no message on the successfull export of control points…
By the way, congratulations on your 600th post 
Hi lubenko,
thanks! :mrgreen:
Honoring the occasion, I finally uploaded an avatar.
As far as I can tell, there are no options that I can choose from.
Oh wait, there is a dropdown in the first explorer window.
So first option, comma separated.
Götz Echtenacher wrote:
It stalled again during texturing and I did not save the last step before starting this process.
Since I worked quite a bit with CPs before, I just minimized and exported them.
It let me do all this without complaint, so I aborted after.
Again, the process could not be terminated and I had to reboot, but this bug is already reported.
Contrary to all indications, the CP-file was NOT CREATED.
So I lost quite a bit of work here.
If the file creation cannot be accomplished, there should be an error message…
Hello Gotz,
If you just minimized texturing and didn’t abort it, I have a bad news (probably not news) for you - your control points are lost.
Problem is that, export CPs process was scheduled after texturing process and it waited for texturing to finish. So if texturing wasn’t aborted or it wasn’t finished, export of CPs wasn’t executed at all.
This is a bug on our side. Export buttons should be disabled or export cps should be executed in other thread.
Thanks for reporting.
Hey Kruzma,
thanks for the reply!
I got to terms with it and did it again.
As usual, it only takes a fraction of the time doing it the second time… 