In the below BP I have it setup that when the VR hands pick up a sword or shield the hands disappear. When the top part of the blueprint for the sword is plugged into the last pin in sequence the hand will disappear when it picks up the sword 1st but not when you pick up the shield 1st unless I swap and have the lower part of the blueprint the shield plugged in to the last pin of the sequence node then the shield hand will disappear if overlapped 1st but not the sword hand if overlapped 1st. I also noticed something similar happening when I tried to set up two similar line of sight BP’s for both hands. Only the one plugged into the last sequence pin would work. This has been off a tick both times.
