Hi,
Just a small one. Looks like the tool tip for these two buttons needs to be swapped with each other.
hello, I have checked it in version 1.0.3.5753 and it seems correct to me like it is
Ok. Not a bug then.
I guess its just a bit confusing as when I click “Reset suggested points” it instead clears all the suggested points rather than enabling them all again like the tool tip suggests.
this may be a bit different issue then, I am trying to reproduce it,
what version and licence type are you using? does this happen just with a specific project, just old ones, new, or all of them?
could you please also specify what all steps do you take until you can recognize this faulty behaviour?
CLI licence.
I perform alignment on a model.Press F3, click on a point on the 3D model. The control point appears in the control points tab.
In the control point list, under the control point just created I have for instance 4 suggested images. I approve with the green “+” 2 images I want to keep. 2 other images remain in the list.
Now when I press,
Clear suggested points - If I’ve highlighted an image in the list that hasn’t been approved it will remove just that image for me. It seems to work as a remove one image at a time option.
Reset suggested points - removes all the images that I didn’t approve. Like what the clear does but in bulk.
Suggest points - Brings back all the suggested images back into the list.
So unsure if they are working as expected? Or my interpretation of their function is wrong? My suggestion is maybe at some point make the tool tip for them explain their functionality better.
I have finally managed to reproduce the issue, it behaves a bit differently for me but it is still a bug since it behaves differently from what the tooltips say, we will do our best to resolve it asap, thank you for letting us know