manual improvement of alignment / sparce point cloud

Vladlen, I DID use control points!
Actually, I am becoming quite good at using them.
But it is VERY time consuming and if then the result is not even close to the competitor, where it took considerably less time in spite of the extremely longer calculation times, then I think it is reasonable to ask if such a tool would not make sense in RC.
I think it could speed up overall processing times (the manual part) a LOT.
And why limit the fantastic speed of RC only to the automatic processing?

I would even be willing to switch back and forth between different programs, but I tried and tried and did not manage to figure out how. I think the aligning process is just too integrated into the cores of the different programs so that it isn’t possible to align it in one and then take tie points / spares point cloud to another one to continue…