Hi Gotz,
I did a settings reset yet again (I do it regularly when things start behaving strange) and I’still getting the same issues. A few more updates from the latest tests on the component with the aligned scans and photos:
- I can get a reconstruction if I disable the laser scans (750M tris on normal res)
- I can get a reconstruction if I disable the photos and set the minimal sampling distance to 2cm (1cm or lower does not work)
If I try laser + photos with a minimal sampling distance of 2cm I get an Unknown Error
So this is getting quite frustrating as I’m still not sure if it’s a software issue or if it’s just a matter of changing a setting. I just wish one of the devs would be bothered enough to give some sort of reply.
Edit:
Ok I now realized that there is also some kind of issue with some areas of the model.
I reduced the size of the reconstruction region and, as expected, I could get a model with both laser scans (3cm res) and photos:
but then I slightly changed the region towards the side of the model (without changing the size or the settings) and got this:
So what could explain this? Too many inputs in specific regions?