How do I execute two tasks at the same time

[richardsonsam]

@ayretek;648080

@richardsonsam

“Any other ideas?”

this was a hint from my above post: (you’ll have to figure out their proper spawn locations from there)

“I also can’t get print strings to work Do you know how?”

type [Print String] to create the node make sure it’s exec input pin is hooked up after whatever you are checking
if you want more than just a message then you can pull from the right side output of almost any variable node (& others) & plug it into the (In String) Input Pin of the [PrintString]

** if you are following that tutorial example - & want to go right & left at the same time you’ll need another attach point & use it’s transform for the side you are adding then use it’s transform like you did for the other side. (& to spawn the course in the 2nd direction as we covered above)

• if this is too much you may have to do more examples & build on your previous coding experience a bit more

good luck

here is my project file if anybody want to take a look.
https://drive.google.com/drive/folders/0B8m3YT06Yd5uSE9OWEJydVB3anM?usp=sharing