Wishgranter wrote:
Hi Bill
you want combine the Components together or need Geo-reference the project ?
Hi Wishgranter,
Here is what I did after I initially ran Align Images. I visually inspected the components and deleted the components that were not useful. I then added 4 control points to 2 photos in each of the remaining components (Component 0 through 9 using Control points 0 through 3). I then ran Align Images again. This resulted in Component 0 (1) and Component 3. I created 4 new Control points, point 4 through 8, and assigned those to Component 0 (1) and Component 3 and ran Align Images again. This resulted in Component 0 (2). I created 5 new Control points, point 9 through 13, and change the type to Ground control and added coordinates. These were assigned to 5 images in Component 0 (2). I then unchecked Control points 0 through 8 (type Tie point) and ran Update under the ALIGNMENT tab. It appears to have achieved the results I was after, but may not have been the proper or most efficient route to get there.
Update (after more playing around):
