Yeah, just tried another run and it failed on normal detail- it worked on preview quality however (though the output orthophoto is not useful).
What hardware are you running? I am using an Alienware core i7-2760QM @ 2.4GHz, 32Gb ram, 2x Nvidia GTX460M, SSD + HDD. I realize running a laptop is not ideal as cooling is not as good as a desktop but I run it on a cooling pad with 3 fans whenever I run these projects and it has worked “reasonably” well previously. I might try a clean install of windows 10 as my licence needs re-activating in the next couple of days (currently running Win7).
Not sure what is going on- is it something in the software that has changed? or is my data not adequate? Last 2 projects I’ve attempted have been ~400 photos from drone flights at ~120m AGL. Flying a bit higher than I usually do and not as much overlap as I am just trying to achieve a basic orthophoto- not super high resolution DEM etc. Maybe the lower quality (compared to other projects) of these images is causing RC to fail (photoscan still processes OK however- just a lot slower). The reported errors for my GCPs (have 8 GCPs spread over project area) are all quite OK as far as I’m concerned… mind you the project fails whether I’m using GCPs or not so I doubt this is an issue.