DoN's 3D Pathfinding for Flying A.I. [Support Thread]

[erol_demirci]

I can not figure out what I’m doing wrong, both the Character and Pawn I made, using the same controller and behavior tree, will not move an inch. I’m using a small “random points in a box”, 50 on all sides with an origin of the AI. I tried it with a random point in a navigable radius and even just telling it to go to a set vector location. It will not move. There is a Don’s nav mesh around it, I’ve tried both, neither of them will get either the character or the pawn to move. Does this work in 4.23?

Hey @ Have you watched the YouTube video the author supplied? Do you have a movement component on the pawn? Is the point located in an object that is an object defined as an ‘obstacle’ in the DonManager properties? Is the DonMesh around the entire area from start to finish? Did you enlarge the DonManager area byusing the object’s transform (increasing scale) or did you use the X Y and Z properties in the DonManager to enlarge the area? Did you change the voxel size?