[ASSETS] [OPEN SOURCE] Tanks, tracks and N-wheeled vehicles

[siverwolfe]

@OldRaven;470137

If you move the suspension or the wheel in the blueprint… make sure you move both.
The suspension and wheel should both have the same xyz coordinates. (I believe they can differ in height coordinate based on what travel you set for the suspension)

I had the same thing with the Tiger setup.

Boredengineer is the one who knows more about torque curves

@BoredEngineer;470202

So first place the wheel where you want them to be and then move suspension handles into the same horizontal coordinates.

But that is the problem. I’m not talking about vertical position.

When the suspension has the same horizontal coordinates, the wheel position is normal, but the tracks

Look like this.

But when I move the suspension right over the wheels, the tracks are fine, but now the wheels are like this:

Thoughts? Is it that the wheel transforms are just bad? Or am I royally ******** up somewhere else?

Also, I apprieciate the info on gear ratios and you looking into the engine horsepower bit. Very useful stuff right there.