[ASSETS] [OPEN SOURCE] Tanks, tracks and N-wheeled vehicles

[BoredEngineer]

@OldRaven;438084

That grey collision mesh is my wheels reference placement so it’s not yours.

If I modify the wheel collision radius in the suspension handles it works.
What is the difference between the radius in the performance tab and the one in the suspension handle? I thought they where the same.

I also have a problem on the left side with the flip animation… I have to look into this… could be pivot related with my wheel.

I will get back to it later.

And yes I did move the suspension handles… will check what I did there before bothering you again

Hmm good question I thought that all unused variables were removed. Which means that collision radius from performance section is still used somewhere, which means there is a bug somewhere… I will look into this.
No worries at all, quite often, just describing a problem helps to find a solution to it.
As far as remember, suspension will move your wheel. Check if position and rotation is properly setup at suspension handle. It’s done in such a way so you could have a spring of suspension working in different directions, not only vertically. I’ll modify Ripsaw setup to demonstrate this.