Turn Splines curves into straight Spline paths?

[Osok]

@dr4ch;306487

Hi SuperSonic68,

Yes you can make Spline points linear:

• If you build the spline in the construction script you have to use the “Set Spline Point Type” node and set the desired spline point to “Linear”.

• If you build the Spline in the Editor then just Select a Spline Point (first Select the whole spline, then a single point) then right click while the point is selected and there you can change the spline point type and set it to linear.

Hope this helps!

I wanted to reply to this and say that it works. Thanks!