Thanks for the quick response
“when you imported the laser scan data, did you imported it as georeferenced in correct coordinate system? Do you have this system set as Project coordinate system?”
I have the project coordinate system as local:1 Euclidean and the output coordinate system as my required coordinates.
I’ve tested by meshing the laser scan data without adding any images, when I export that using the same coordinate system I imported it with it lines up with a pointcloud thats not been through RC. Its only once adding images that the position gets shifted slightly out of place.
“Are you using a component workflow or did you just imported images to the project?”
I’ve tried both ways with the image sets to see if that would make any difference but I was getting the same results either way.
“Do you have some GCPs in this project?”
I had control points in the image component when using the component workflow. I did a test just importing the images directly and then aligning, that had no control points. It didn’t seem to make a difference.