Hi Chris,
In past projects it occurred when mixing UAV (Phantom 4) photos with ground photos. I learned the hard way that it was not just in RC but also in the exported mesh, which looked super messed up once finished reconstructing (which took ages).
The screenshot above is from a different project, however, it was just UAV images. There’s about 6 different groups of photos, and I’ve used about 10 control points in around 18 photos. Each photogroup I’ve chosen the first middle and last photo to have the control points in to ensure everything was tied in correctly.
Perhaps I am overdoing it with control points? I might restart the project and realign it with no control points, and then add control points until the model aligns itself into one component.
Could this be a hardware or reconstruction settings issue?